Fernco® QC-101 Qwik Cap, 1-1/2 in, PVC

Qwik Caps offer a quick, easy way to cap pipe ends, test pipes and clean-outs. Made of flexible PVC, their durability causes them to be suitable for above-ground or under-ground use. To install, simply place over open end of pipe and tighten to 60 in lbs. of torque. Remember to hand tighten when installing on corrugated pipe.

Fernco® Qwik Cap, Series: QC Series, Fitting/Connector Type: Cap, 1-1/2 in Nominal, 0.965 in Length, PVC, -30 to 180 deg F, 2.269 in, Domestic

• Fast, easy installation
• Permanent or temporary cap
• Suitable for above or below ground use as an permanent solution to cap pipe ends, test pipes and cleanouts
• Low cost and reusable
• Convex face minimizes ballooning
• Flexible PVC gasket complying to ASTM D 5926
• 300 series stainless steel clamp
• 60 in lb installation torque
• Flexible PVC 60 duro shore a
• 4.3 psi tested pressure
• Fits 1-1/2 in plastic, 1-1/2 in cast iron, 1-1/2 in copper, 1-1/2 in steel

• Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Fernco_22U-205_Catalog.pdf
• Specification Sheet https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Fernco_QC-138_Specification_Sheet.pdf